1. REMOVE CYLINDER BOOT

(a) Using a screwdriver, remove the 4 set rings and 4 cylinder boots from the disc brake caliper. HINT: Tape the screwdriver tip before use.

2. REMOVE FRONT DISC BRAKE PISTON

(a) Install one side of the disc brake pad.

(b) Install a wooden plate between the pistons of the disc brake caliper to prevent the pistons from jumping out.

(c) Using an air gun, gradually apply air and remove the 2 disc brake pistons from the cylinder.

CAUTION:

Do not place your fingers in front of the pistons when using compressed air.

(d) Remove the brake pad and wooden plate.

(e) Temporarily install the 2 disc brake pistons that were removed. Then install the disc brake pad to the side in which the 2 disc brake pistons were temporarily installed.

(f) Install a wooden plate between the pistons of the disc brake caliper to prevent the pistons from jumping out.

(g) Using an air gun, gradually apply air and remove the 2 disc brake pistons from the other side of the cylinder.

3. REMOVE PISTON SEAL

(a) Using a screwdriver, remove the 4 piston seals from the disc brake caliper. NOTICE: Do not damage the inner cylinder and cylinder groove. HINT: Tape the screwdriver tip before use.

4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP

5. REMOVE FRONT DISC BRAKE BLEEDER PLUG